92

Hardware Side Cover

Square head set screw locks the pivot pin to the side cover.

Hardware Washer Kit

A 16 piece brass washer add on kit for the model 92 Maytag brass bolt kit.

Head & Piston

Honed head and a good piston

Head, Piston, Rod

Flywheel Supply Product. Made in the USA.

Kill Switch Brass

This new kill switch is designed for your model 82 & 92 Maytag engine, featuring a brass rod for an enhanced look and a sleek black tab. Perfect for completing your restoration. Also available in uncoated steel to look like the original. (SKU#...

Kill Switch Mounting Bolt

Mounting bolt for kill switch NOT brass

Kill Switch Steel

This new kill switch is designed for your model 82 & 92 Maytag engine, featuring a uncoated steel rod just like the original and a sleek black tab. Perfect for completing your restoration. Also available in brass for an enhanced look(SKU# 202)

Kill Switch Tab, Spring Mount

Early 92 holds the kill switch to carb. Also used to mount the pedal spring to skids for the short deep gas tank.

Kit, Points

Flywheel Supply Product. Made in the USA.

Mag Coil Boot - 2 pack

Used on the Model 92 mags where the wire leads out of the coil. These are a direct fit for the larger cover and they can be trimmed to fit the smaller cover. I can trim them down for you if you would like me to. You get 2 boots in the listing for the...

Mag Coil Cover - Large

1 3/4" center to center

Mag Coil Cover - Small

1 3/8" center to center